Kitchen Cabinet Paint - The molding tops off the job

Try finishing a kitchen cabinet work a step further by adding some form in front of the furniture surface. We will create an interesting touch to your room without spending a lot more than you do on a simple repair. forms of wearing the cabinets can be easily made.

The basic tasks

The first thing is to do the finishing of the base. Remove the doors and drawer fronts and move out of the hardware. Scrub withDegreaser until completely free of grease and dirt. In this way you can stick your color on the surface. After the wood has dried, you can paint to clean sand. Put three or more very thin layers of paint, sanding and allow to dry between each layer. Always clean the sanding dust before painting again.

If you have completed the task at that time, decide what kind of shapes you want on your doors and drawer fronts, cabinet. You can thin, flatForms easily. lattice shapes and forms of screen work, like other types of flat shapes. There are about 1 / 4 inch thick. You must also consider the desired width. If you want one of the smaller shapes, you can screen molding, which is large in 3 / 4 inch rule. Lattice molding, in a 1 / 8 to March 1 / 4 inches wide and not narrow.

Hold Up Against the pre-printed sample

To learn how to complete the project finishing, I want to take a few small piecesof each variety you want to take home. Hold it against the door and try to create a sense of how to get them in different models look ante. Once you find out, you are ready to move forward. Measurements on your doors and drawer fronts to determine how many forms you like to attract. Buy the molding.

Once you have the forms, it is time to first and then paint them. If you did this, you can start cutting them. Use aMiter, a miter saw power if you have one available to you around the corners are square. There are two ways to continue with your task at this point. You can cut all kinds of items at a time and then assemble the cabinet doors and drawer fronts. The other option is to cut the shapes for each drawer front or door, cut and paste, and then the other.

Use yellow wood glue to install your cabinet molding Onto

The best way to put itStamping in your closet surfaces with yellow wood glue. Need to put a thin layer of glue in the bottom of each piece to attach. Then you print, and some pressure on them for half an hour. You can do this by a certain weight on it or doing some brad through it. The cabinet body is your best if you use the brad, because the part could be formed with a simple weight shift. Wipe glue leaked out, and let the pieces dry.

If youhave made doors and drawer fronts used again, the next job will be to add in your hardware, hand-selected. When this is done, finish cooking is your mobile work.